1. First, pair 2 bridges;
2. Access the wireless bridge through the computer, modify the computer IP address, and enter the IP of the main bridge and the slave bridge respectively in the browser to access the management page;
3. The bridge defaults to a static IP, respectively 192.168.255.XXX+LED number, refer to the figure below:
4. Suppose your subnet is: 100.23.9.xxx
5. Set a new IP address in "Advanced Settings" --> "LAN" for master wireless bridge,click “Apply” to save.
IP Address: 100.23.9.10
Subnet Mask: 255.255.255.0
Default Gateway: 100.23.9.254
6. Set a new IP address in "Advanced Settings" --> "LAN" for salve wireless bridge,click “Apply” to save.
IP Address: 100.23.9.11
Subnet Mask: 255.255.255.0
Default Gateway: 100.23.9.254
7. After you change the IP, they will remain paired. At this time, you must use the new IP address of the bridge to access the management page of the bridge. In your network, you can access the bridge through 100.23.9.10 or 100.23.9.11.
8.But if your computer network transmission changes, you need to modify the IPv4 address to 100.12.9.xxx to access the wireless bridg.
